1

(0 replies, posted in Technical)

I constantly get negative values of measurement. And next value is always linarly smaller then previous. What I'm doing it wrong?

Second question. How to properly search for load balance. My process is this.
- put scale in config mode
- put a wooden board on scale
- put some weight on scale
- browse with browser to UI
- Search for WIFI - save
- sync time, set 1 minute interval, save
- put motor on position 5000 or more
- after it reaches 5000, press button search for balance
- after that, tare, tare, tare, and remove config jumper.

Is this ok? Should I search for balance multiple times?

How should scale operate when the motor reaches position 0 or less. Should it move up slowly to 100, 200, 300 and then back again?

Please advise

2

(7 replies, posted in General)

Hello Pierre,

Thank you, package received 3 days ago. ATM everything ok.  Have managed to assembly one scale together.

Thank you again, and appologies for any troubles.

Peter

3

(7 replies, posted in General)

Hi Pierre,

Please be aware, that 3 weeks ago I have sent you all the money and until today I did not get nor any mail nor any update regarding my order.

I understand that you have busy life, but If you cannot provide timely response and you cannot produce scales in some normal timing, then ... I don't know why are you offering them.

I have ordered scales because I want to use them. I have paid them 100%, but on your side there is no response. What should I do? What would you do if you were on my side?

Im waiting for your response!

4

(7 replies, posted in General)

Hi!

Can you please update me, what is going on with my order?

Best regards
Peter Lukan

5

(1 replies, posted in DIY)

Great project and big thanks for sharing.

What kind of material is suggested for building this scale?
Something that will not rust and 3 mm? 5mm? More?

Is possible to order just PCB with soldered items?

Enough for now.

Best regards,
Peter